Forums Common Property Current Page

  • This topic has 1 reply, 2 voices, and was last updated 15 years ago by .
  • Creator
    Topic
  • #7637 Reply | Quote

    Our four unit block has two large two level units (part of a heritage listed building) with two new single storey units added on. Recently the OC changed the fire alarm system so that all units had just two sensors.

    We previously had ten sensors; there are timber floors between the two large units and feel more are needed. The single sensor on our lower floor is potentially two closed doors away from the kitchen.

    The OC voted (reluctantly) to allow us two more sensors but the managing agent told us this was against strata laws. She was unable to tell us which laws.

    We'd very much appreciate knowing the law on this.

    Thank you

Viewing 1 replies (of 1 total)
  • Author
    Replies
  • #13702 Reply
    Austman
    Flatchatter

      Assuming you are in NSW, here is some info about where to locate smoke detectors: https://www.fire.nsw.gov.au/page.php?id=443

      As per the link, it might well be the case that only one is needed for each storey.  And the recommendation says “it is better not to install them in kitchens, bathrooms, laundries and garages”.

      I have a two floor apartment in a fairly new complex  and we only have one per floor.  The detectors inside each apartment are mains powered (with battery back-up) and are not connected to the building's Fire Panel (meaning that the alarm is local – but it is loud enough inside the apartment).  We also have detectors in the Common Areas of our building that are also mains powered but have a central battery back-up. These are connected to our building's Fire Panel which will ring bells/alarms everywhere if one goes off.

      We also have water sprinklers in each apartment and in common areas.  Only if one of these triggers will a call will be automatically made to our monitoring service who in turn will call the fire brigade.

      Are your internal apartment detectors connected to your building's central Fire Panel?  If so then it would be an OC matter to maintain them. Ours are not, probably because of the number of false alarms that would happen. 

      Perhaps it not a law that your manager refers to but a recommendation?  But if you really wanted to install more detectors, you could of course buy stand-alone ones even from your supermarket.  These are battery powered only, so you need to check/change the battery often.

    Viewing 1 replies (of 1 total)
    Reply To: Fire sensors
    PLEASE ... If your property is not in NSW, mention its location (state). Don't identify companies or individuals by name. Don't mention or promote your company or services. Keep acronyms and initials to a minimum. Please, don’t use “quote” unless there is a specific point to which you wish to refer, then highlight (define) that specific passage before you click on "quote". Otherwise just use reply. THANKS.

    You can use BBCodes to format your content.
    Your account can't use all available BBCodes, they will be stripped before saving.

    Your information:




    Forums Common Property Current Page