Forums Common Property Current Page

  • This topic has 3 replies, 3 voices, and was last updated 10 years ago by .
  • Creator
    Topic
  • #10619 Reply | Quote

    Subject – Ventilation & mould/mildew problems in bathroom

    I am the owner of a flat involving a double brick exterior wall construction (early 1970s). In relation to the bathroom,  there are two terracotta wall vents on the outside and two vents on the inside. Four (4) vents in total located on either side of the bathroom window. The window is a sliding type, with a small mesh section inserted in the sliding pane. Each wall vent has a section of “flyscreen” attached/glued on to the back (from within the wall cavity). The flyscreen is blocked with dust for the inside vents, assume the same for the outside vents. The flat is located on the third level of the block. Some questions:
    Q1 How do you remove the dust without dislodging the flyscreen?
    Q2 Accept the flyscreen inserts are useless but realise there removal will restore proper ventilation to the bathroom. Therefore just push the flyscreen inserts off the vents, and if necessary reattach flyscreen (on the face of the vent). Note – I cannot access the external vents from outside the building, and cannot see them from the inside.
    Q3 If these vents are not functional for air circulation, am I or the OC liable for the cost to install an exhaust fan if the wall vents are blocked and/or not adequate/functional for removing moist air (and the vents are recognised as common property)
    Q4 Just keep the window open all seasons – even in cold/freezing winter
    Q5 If mould/mildew appears keep treating it with the right product/s eg vinegar, bleach, borax

    Hope Flat Chat can help

    Thanks Max

Viewing 3 replies - 1 through 3 (of 3 total)
  • Author
    Replies
  • #25412 Reply
    Jimmy-T
    Keymaster

      Based on my understanding of pre-1974 strata law, the line between lot property and common property is down the middle of the external wall so the external vents would be owners corp responsibility and the internal ones lot owner responsibility.  In the first instance, ask the OC to repair or replace the external vents and hope they do the internal ones too.

      If you want to be alerted when anyone replies to your posts or responds to this topic, please register and login, then you will be able to subscribe to the topic. The opinions offered in these Forum posts and replies are not intended to be taken as legal advice. Readers with serious issues should consult experienced strata lawyers. NB: Longer threads may spill over to additional pages - look for the numbers on the bottom right, under the last post.
      #25415 Reply
      scotlandx
      Flatchatter

        In relation to ventilation and damp/mould generally, bear in mind that the bathroom would have been built to the building standards that applied at the time.  Presuming that the air vents and window met those requirements then it is arguable whether the OC has any further responsibility.

        Air vents by themselves will not usually deal with condensation in a bathroom from a shower.  The advice we have usually had is that you should open the window at least after the shower to let the condensation out.  You don’t have to keep the window open at all times.

        You could apply to the OC to install an exhaust fan – as noted above query whether they have to pay, as the condensation is coming from inside.

        In terms of treating mould generally, don’t use bleach or borax etc., this will not kill the mould.  The best treatment is oil of cloves diluted in hot water.

        #25423 Reply

        JimmyT & scotlandx – Thanks for your valuable feedback. You’ve both raised some very useful points and raised my awareness about understanding & treating this problem – Regards Maxd12

      Viewing 3 replies - 1 through 3 (of 3 total)
      Reply To: Ventilation
      PLEASE ... If your property is not in NSW, mention its location (state). Don't identify companies or individuals by name. Don't mention or promote your company or services. Keep acronyms and initials to a minimum. Please, don’t use “quote” unless there is a specific point to which you wish to refer, then highlight (define) that specific passage before you click on "quote". Otherwise just use reply. THANKS.

      You can use BBCodes to format your content.
      Your account can't use all available BBCodes, they will be stripped before saving.

      Your information:




      Forums Common Property Current Page