Forums Talkin’ ’bout a renovation Current Page

  • Creator
    Topic
  • #11818 Reply | Quote
    gbrownie
    Flatchatter

      We have a lot owner who say they had approval to drill (jackhammer) into the concrete slab to change plumbing 

       

      they had in the bylaw, “removal of existing fixtures and fittings and replace with new fixtures and fittings”

      ”removal of floor tiles and wall tiles and replace with new floor tiles and wall tiles” 

      so the owners Corporation never expected new plumbing 

      what do you think the definition of fixtures and fittings are? Is it plumbing (pipes) or just Things attached in the same spot without moving them?

    Viewing 4 replies - 1 through 4 (of 4 total)
    • Author
      Replies
    • #30170 Reply
      scotlandx
      Flatchatter

        Plumbing is not fixtures and fittings.

        Fixtures and fittings are things like light fittings, taps, carpets etc. Not sure why you would have a by-law for those.

        #30173 Reply
        gbrownie
        Flatchatter
        Chat-starter

          @scotlandx said:
          Plumbing is not fixtures and fittings.

          Fixtures and fittings are things like light fittings, taps, carpets etc. Not sure why you would have a by-law for those.  

          They also had a bylaw for window furnishings and then ripped out all the windows and replaced with their own saying they had approval 

          – they still don’t have their window furnishings up 😛

          we’re at NCAT next month but just putting in definition about fixtures and fittings and I was 99.9% sure I was correct just needed a sounding board 🙂 

          thank you 

          #30176 Reply
          Jimmy-T
          Keymaster

            Presumably your action at NCAT is to force them to restore common property or to pay for the damage and changes to common property then take responsibility for the changes they have made?

            If you want to be alerted when anyone replies to your posts or responds to this topic, please register and login, then you will be able to subscribe to the topic. The opinions offered in these Forum posts and replies are not intended to be taken as legal advice. Readers with serious issues should consult experienced strata lawyers. NB: Longer threads may spill over to additional pages - look for the numbers on the bottom right, under the last post.
            #30179 Reply
            gbrownie
            Flatchatter
            Chat-starter

              @JimmyT said:
              Presumably your action at NCAT is to force them to restore common property or to pay for the damage and changes to common property then take responsibility for the changes they have made?  

              Hi Jimmy 

              yes it is to restore common property (windows and balcony door) back to sliding from bifold and penalty for replacing 9 other common property windows that now look 20% different from what was there before (shape and size is incorrect) 

              they also did extra plumbing works and their builder said they were trying to cut a core hole with a jackhammer?! And slipped.

              thats the reason why there is a hole in the concrete slab between the two lots 

              the builder even put in writing that they covered the hole with a rag and concreted over the top, the lot below found water damage and the rags sticking out of their (my) ceiling and the lot owners are refusing the pay for damages as they said they simply deny all responsibility 

              but that’s why I was trying to figure out if somehow they could use the loop hole of fixtures and fittings as the reason of them drilling into the slab to change plumbing 

            Viewing 4 replies - 1 through 4 (of 4 total)
            Reply To: Definition of Fixtures and Fittings (Bathroom)
            PLEASE ... If your property is not in NSW, mention its location (state). Don't identify companies or individuals by name. Don't mention or promote your company or services. Keep acronyms and initials to a minimum. Please, don’t use “quote” unless there is a specific point to which you wish to refer, then highlight (define) that specific passage before you click on "quote". Otherwise just use reply. THANKS.

            You can use BBCodes to format your content.
            Your account can't use all available BBCodes, they will be stripped before saving.

            Your information:




            Forums Talkin’ ’bout a renovation Current Page